. . . .Our illustrated catalogue is now available. . . .UK customers - send 50p in stamps for a copy of the catalogue

1051 SUBMERSIBLE PRESSURE GAUGE HOSE

For use with our 1092 gauge. One end has ⁷/₁₆ UNF male fitting with restricted hole. Other end is ⁷/₁₆ UNF female swivel fitting so that gauge turns 360°. Will fit most other gauges available.

1051/SH SUBMERSIBLE PRESSURE GAUGE HOSE

As our 1051 hose but only 8" (20cm) long for use with bale out sets.

5040 COMPRESSOR CHARGING HOSE

Rubber covered wire braided hose, 2 meters long with 1/4 BSP swiveling nuts and 60° cone seal at each end with 'O' ring for 100% seal. Other end fittings and any length available to special order. Max working pressure is 300 Bar. Stainless steel end fittings available to special order.

5041 COMPRESSOR CHARGING HOSE

Polyurethane covered fabric braided hose. More durable than rubber. Even 'kinking' will not cause failure. 2 meters long with 1/4 BSP swiveling nuts and 60° cone seats ay each end with 'O' ring for 100% seal. Other end fittings available and any length available to special order. Max working pressure is 330 Bar. stainless steel fittings available to special order.

5042 P.T.F.E. CORE OXYGEN HOSE

Stainless steel over braided with fittings in brass with 1/4 BSP swiveling nut and 60° cone seat at each end with 'O' ring for 100% seal. Other end fittings and any length available to special order. Max working pressure is 330 Bar. stainless steel end fittings available to special order.

5042/90 P.T.F.E CORED HOSE FOR MIXED GAS

300mm length hose with 1/4 BSP end fittings. One end has a 90° swept fitting. Any length supplied to special order.

5043 DECANTING HOSE

Rubber covered wire braided hose 30cm long with 1/4 BSP swiveling nuts each end. For use with any of our 1/4 BSP charging clamps. As used on our 1200/1205 assembly's. stainless steel end fittings available to special order.

5045 L.P. HOSE FOR REGULATORS

Very flexible high quality rubber hose with chrome plated brass re-usable end fittings. Will fit most current regulators. Standard length is 70cm with a working pressure of 25 Bar. Any length is available to special order.

Send mail to subaqua-products.com with questions or comments.
Last modified: 04 August, 2004